H3C交换机的基本配置.docx
- 文档编号:15812928
- 上传时间:2023-07-08
- 格式:DOCX
- 页数:5
- 大小:39.36KB
H3C交换机的基本配置.docx
《H3C交换机的基本配置.docx》由会员分享,可在线阅读,更多相关《H3C交换机的基本配置.docx(5页珍藏版)》请在冰点文库上搜索。
H3C交换机的基本配置
H3C交换机的基本配置
H3C交换机的基本配置
1.交换机支持的命令:
交换机基本状态:
switch:
;ROM状态,路由器是rommon>
hostname>;用户模式
hostname#;特权模式
hostname(config)#;全局配置模式
hostname(config-if)#;接口状态
交换机口令设置:
交换机设置IP地址:
switch(config)#interfacevlan1;进入vlan1
switch(config-if)#ipaddress ;设置IP地址
switch(config)#ipdefault-gateway ;设置默认网关
switch#dirflash:
;查看闪存
交换机显示命令:
switch#write;保存配置信息
switch#showvtp;查看vtp配置信息
switch#showrun;查看当前配置信息
switch#showvlan;查看vlan配置信息
switch#showinterface;查看端口信息
switch#showintf0/0;查看指定端口信息
2.路由器支持的命令:
路由器显示命令:
router#showrun;显示配置信息
router#showinterface;显示接口信息
router#showiproute;显示路由信息
router#showcdpnei;显示邻居信息
router#reload ;重新起动
路由器口令设置:
router>enable;进入特权模式
router#configterminal;进入全局配置模式
router(config)#hostname ;设置交换机的主机名
router(config)#enablesecretxxx;设置特权加密口令
router(config)#enablepasswordxxb;设置特权非密口令
router(config)#lineconsole0;进入控制台口
router(config-line)#linevty04;进入虚拟终端
router(config-line)#login;要求口令验证
router(config-line)#passwordxx;设置登录口令xx
router(config)#(Ctrl+z);返回特权模式
router#exit;返回命令
路由器配置:
router(config)#ints0/0;进入Serail接口
router(config-if)#noshutdown;激活当前接口
router(config-if)#clockrate64000;设置同步时钟
router(config-if)#ipaddress ;设置IP地址
router(config-if)#ipaddress second;设置第二个IP
router(config-if)#intf0/0.1;进入子接口
router(config-subif.1)#ipaddress ;设置子接口IP
router(config-subif.1)#encapsulationdot1q ;绑定vlan中继协议
router(config)#config-register0x2142;跳过配置文件
router(config)#config-register0x2102;正常使用配置文件
router#reload;重新引导
路由器文件操作:
router#copyrunning-configstartup-config;保存配置
router#copyrunning-configtftp;保存配置到tftp
router#copystartup-configtftp;开机配置存到tftp
router#copytftpflash:
;下传文件到flash
router#copytftpstartup-config;下载配置文件ROM状态:
Ctrl+Break;进入ROM监控状态
rommon>confreg0x2142;跳过配置文件
rommon>confreg0x2102;恢复配置文件
rommon>reset ;重新引导
rommon>copyxmodem:
flash:
;从console传输文件
rommon>IP_ADDRESS=10.65.1.2;设置路由器IP
rommon>IP_SUBNET_MASK=255.255.0.0;设置路由器掩码
rommon>TFTP_SERVER=10.65.1.1;指定TFTP服务器IP
rommon>TFTP_FILE=c2600.bin;指定下载的文件
rommon>tftpdnld;从tftp下载
rommon>dirflash:
;查看闪存内容
rommon>boot;引导IOS
静态路由:
iproute ;命令格式
router(config)#iproute2.0.0.0255.0.0.01.1.1.2;静态路由举例
router(config)#iproute0.0.0.00.0.0.01.1.1.2;默认路由举例
动态路由:
router(config)#iprouting;启动路由转发
router(config)#routerrip;启动RIP路由协议。
router(config-router)#network ;设置发布路由
router(config-router)#negihbor ;点对点帧中继用。
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- H3C 交换机 基本 配置